sjhf0210 szepni
Doczy: 04 Wrz 2018 Posty: 83
|
Wysany: Sob Sty 19, 2019 7:55 am Temat postu: 3 Ways to Fix The Request Failed Due to A fatal Device Hardw |
|
|
|
Today we will guide you 7 fastest solutions to fix the last USB device malfunctioned and Windows does not recognize it error happened on the computer while you were trying to connect the USB device.
Bitwar Data Recovery for Windows downloadBitwar Data Recovery for Mac download
When you trying to connect the USB device with the computer and willing to find some important documents you stored on the USB device, suddenly the Windows informs an error message: USB device not recognized, the last USB device you connected to this computer malfunctioned, and Windows does not recognize it.
7 Fastest Solutions to Fix the Last USB Device Malfunctioned Error
We found that many users had such errors no matter on Windows 7/8/10 when they tried to connect the USB device with the computer, which means, USB does not show up on the computer and you cannot access the USB device at this moment.
Although this problem is quite the head-scratcher, but it doesn't means we cannot fix it. The following are 7 fastest solutions that any Windows user can give a shot and try to get rid of the last USB device malfunctioned problems.
7 Fastest Solutions to Fix the Last USB Device Malfunctioned Error
Solution 1. Remove and then plug the power supply to fix the last USB device malfunctioned error
Unplug the USB device from the Computer >> Turn off the computer >> Remove the power supply of the computer >> Plug the power supply back to the computer after 20-30 seconds >> Restart the computer >> Plug on the USB device again
Solution 2. Unplug the USB device and reconnect with computer to fix the last USB device malfunctioned error
Unplug the USB device from the computer >> clean the USB port of the device clamp the position of the USB port and flash chip inside the USB housing >> Reconnect the USB device with computer
Solution 3. Configure the USB Root Hub to fix the last USB device malfunctioned error
Press WIN+X and then choose Device Manager >> Find the Universal Serial Bus controllers >> Right click on USB Root Hub >> Properties >> Power Management >> Check Allow this computer to turn off this device to save power >> Click Ok >> Plug the USB device again with the computer.
Solution 4. Disable and then enable the Generic USB hub to fix the last USB device malfunctioned error |
|